Installing Series 505 Remote Base Controller; Rbc Placement In Bases; Dipswitches; Setting Rs-232 Port Baud Rates (Sw 2) - Siemens SIMATIC TI555 System Manual

3.7

Installing Series 505 Remote Base Controller

RBC Placement in
Bases

Dipswitches

Setting RS-232 Port
Baud Rates (SW 2)
Installing Series 505 System Hardware
3-16
The RBC must always be installed in the second slot from the left (adjacent
to the power supply module) in a remote base.
There are two dipswitches, SW 2 and SW 3, located on the components side
of the RBC. SW 2 (Figure 3-13) is used to set baud rates. SW 3 is a
factory-use-only switch.
Off
1 2 3
On

Figure 3-13 RBC Dipswitch Location

Dipswitch SW 2 is used to set baud rates for the RBC RS-232 port. The
RS-232 port is used to program the controller or to troubleshoot from a
remote I/O base.
See Figure 3-13 for positions of SW 2 on the board; refer to Table 3-4 for
individual dipswitch settings.

Table 3-4 RBC SW 2 (RS-232 Port) Baud Rate Settings

Baud Rate
On (1)
19200
On (1)
9600
Off (0)
2400
On (1)
1200
Off (0)
300
4
Dipswitch
1 2
On (1)
On (1)
On (1)
Off (0)
Off (0)
Front bezel
SW 2
3
Off (0) On (1)
On (1) On (1)
On (1) On (1)
On (1) On (1)
On (1) On (1)
TI545/TI555 System Manual
4