First Ramp-Up; Basic Ramp-Up Of The System Software (Sw 2.2 And Higher) - Siemens SINUMERIK 840Di Manual

06.03
6.2

First ramp-up

6.2.1

Basic ramp-up of the system software (SW 2.2 and higher)

Objective of basic
ramp-up
Delivery state
Installing the
software
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
After a basic start-up described in the following, the following prerequisites must
be provided:
S
SINUMERIK 840Di-NC and PLC are operated in cyclic operation
S
If a machine control panel is connected, no alarms or messages should be
present
S
The displayed axes of the NC can be traversed by simulation.
At delivery, the hard disk of the PCU is already partitioned for running SINUM-
ERIK 840Di and any other SINUMERIK applications. The software applications
included in the delivery are ready for installation and are located on the hard
disk under D:\Setup\Apps\<Application1> . . . <Application n>.
active
C: D:
FAT16
Name: DOS Name:
Contents: DOS 6.2 Contents: Images,
Tools
Primary partition Extended partition
with logic drive
Fig. 6-1 Partitioning of the harddisk
When the PCU is first booted, the following menu is displayed:
Welcome to SINUMERIK !
These SINUMERIK products will be installed now:
<Application 1> <Version>
<Application n> <Version>
6 Turning On and Ramp Up
E:
FAT16 NTFS
Install Name: WinNT
Contents: WinNT 4.0
Setups,
Updates
Primary partition
: :
: :
Install NOW
Install at NEXT REBOOT
CANCEL installing
6.2 First ramp-up
F:
NTFS
Name: 840Di system
Contents: empty
Primary partition
6-175