Siemens SINUMERIK 840Di Manual page 386

10 NC Start-Up with HMI Advanced
10.6 Digital and analog I/O devices
Number of
output bytes
Hardware
assignment:
input bytes
Hardware
assignment:
output bytes
10-386
ET200
2 output bytes
ADI4
2 output bytes.
Note
Although only four output bytes are used, five must be declared. The 1st output
byte is always assigned to the MCI board extension module even if it is not
installed:
– MD10360: FASTIO_DIG_NUM_OUTPUTS = 5
The following input bytes are used by the NC:
ET200
Both input bytes of the input module (slot 6)
– MD10366: HW_ASSIGN_DIG_FASTIN[0] = H05000080 (128
– MD10366: HW_ASSIGN_DIG_FASTIN[1] = H05000081 (129
The 4th of the 4 input bytes of the signal module (slot 7)
– MD10366: HW_ASSIGN_DIG_FASTIN[2] = H05000085 (133
ADI4
The high byte of the input word (slot 21)
– MD10366: HW_ASSIGN_DIG_FASTIN[3] = H0500014B (331
The following output bytes are used by the NC:
ET200
The 1st output byte of the output modules (slots 4 and 5)
– MD10368: HW_ASSIGN_DIG_FASTOUT[0] = H05000080 (128
– MD10368: HW_ASSIGN_DIG_FASTOUT[1] = H05000082 (130
ADI4
Both output bytes of the output word (slot 22)
– MD10366: HW_ASSIGN_DIG_FASTOUT[2] = H0500014A (330
– MD10366: HW_ASSIGN_DIG_FASTOUT[3] = H0500014B (331
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
06.03
)
D
)
D
)
D
)
D
)
D
)
D
)
D
)
D