Siemens SINUMERIK 840Di Manual page 360

10 NC Start-Up with HMI Advanced
10.5 Axes and spindles
Axis-specific
31, ... 1.5/1.6
31, ... 2.4–2.7
31, ... 4.6/4.7
31, ... 12.7
Axis-specific
31, ... 60.4 / 60.5
31, ... 64.6/64.7
Machine data
Table 10-40 Referencing: Machine data
Number
General ($MN_ ...)
11300 JOG_INC_MODE_LEVELTRIGGRD
Channel-specific ($MC_ ...)
20700 REFP_NC_START_LOCK
Axis-specific ($MA_ ...)
30200 NUM_ENCS
30240 ENC_TYP
30242 ENC_IS_INDEPENDENT
31122 BERO_DELAY_TIME_PLUS
31123 BERO_DELAY_TIME_MINUS
34000 REFP_CAM_IS_ACTIVE
34010 REFP_CAM_DIR_IS_MINUS
34020 REFP_VELO_SEARCH_CAM
34030 REFP_MAX_CAM_DIST
34040 REFP_VELO_SEARCH_MARKER[n]
34050 REFP_SEARCH_MARKER_REVERSE[n]
34060 REFP_MAX_MARKER_DIST[n]
34070 REFP_VELO_POS
34080 REFP_MOVE_DIST[n]
34090 REFP_MOVE_DIST_CORR[n]
34092 REFP_CAM_SHIFT
34100 REFP_SET_POS[n]
34102 REFP_SYNC_ENCS
34110 REFP_CYCLE_NR
34120 REFP_BERO_LOW_ACTIVE
34200 ENC_REFP_MODE[n]
34210 ENC_REFP_STATE[n]
10-360
Signals from PLC to axis/spindle
Position measuring system 1/position measuring system 2
Reference point values 1 to 4
Traversing keys minus/plus
Delayed reference-point approach
Signals from axis/spindle to PLC
Referenced, synchronized 1/referenced, synchronized 2
Traversing command minus/plus
Identifier Name
INC/REF in inching mode/continuous mode
NC start lock without reference point
Number of encoders
Actual-value encoder type
Encoder is independent
BERO delay time in plus direction
BERO delay time in minus direction
Axis with reference cam
Reference-point approach in minus direction
Reference point approach velocity
Max. distance to be traversed to the reference
cam
Reference point creep speed
[encoder number]
Direction reversal at reference cam
[encoder number]
Max. distance to be traversed to the reference
cam; max. distance to 2 reference marks with
distance-coded measurements [encoder num-
ber]
Reference point positioning velocity
Reference point distance/target point with dis-
tance-coded system [encoder number]
Distance-coded reference point/absolute offset
[encoder number]
Electronic reference cam offset for incremental
measuring systems with equidistant zero marks
Reference point value [reference point number]
Actual-value adjustment to the referencing
measuring system
Axis order on channel-specific referencing
Polarity change of BERO
Referencing mode [encoder number]
Status of absolute encoder [encoder number]
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
06.03
A2
H1
H1
Ref.
H1
G2
G2
S1
S1