Dos Shell - Siemens SINUMERIK 840Di Manual

06.03
6.5.3

DOS Shell

Operator action
Version display:
Basic software
6.5.4 Start Windows NT (Service Mode)
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
PLEASE SELECT
1 Install/Update SINUMERIK System
2 SINUMERIK Tools and Options
3 DOS Shell
4 Start Windows NT (Service Mode)
5 SINUMERIK System Check
7 Backup/Restore
8 Start PC Link
9 Reboot (warm restart)
P 840Di Services
Your Choice [1,2,3,4,5,7,8,9,P] ?
Select DOS Shell with key "3".
The DOS command interpreter is started.
To leave the DOS Shell enter "exit" and conclude the command with the "Re-
turn" key.
The version of the basic software is displayed with the command:
S
C:\BaseVers.txt.
PLEASE SELECT
1 Install/Update SINUMERIK System
2 SINUMERIK Tools and Options
3 DOS Shell
4 Start Windows NT (Service Mode)
5 SINUMERIK System Check
7 Backup/Restore
8 Start PC Link
9 Reboot (warm restart)
P 840Di Services
Your Choice [1,2,3,4,5,7,8,9,P] ?
Under menu item: 4 Start Windows NT (Service Mode), you can perform the
following actions:
S
Standard Windows NT (without starting SINUMERIK HMI)
After the PCU has started up, Windows NT is started without any
SINUMERIK HMI
S
Original SINUMERIK HMI environment
SINUMERIK HMI is started in the as-delivered state, i.e. the content of the
directories:
– F:\ADD_ON
– F:\USER
– F:\OEM
– C:\RUNOEM
has been backed up and the directories then cleared.
6 Turning On and Ramp Up
6.5 Service menu
6-195