Default Address Assignment - Siemens SINUMERIK 840Di Manual

06.03
5.3

Default address assignment

Standard MPI
addresses
PG 740
MPI bus
X
Address at MPI bus
Fig. 5-2 Default addresses at the MPI bus with SINUMERIK 840Di
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
The following figure 5-2 shows a SINUMERIK 840Di with the user interface run-
ning on the PCU:
S
840Di start-up or HMI Advanced
and the further components connected on the MPI bus:
S
Machine control panel (MCP) or interface customer operator panel
S
Handheld terminal (HT 6)
S
SIMATIC programming device PG 740
with standard assignment of the MPI addresses.
MCP/interface
customer operator
panel
0
2
PLC
NC
3
5 MPI Communication
5.3 Default address assignment
HT 6
6 14
SINUMERIK 840Di
(PCU with MCI board)
1
840Di-start-up/
HMI Advanced
5-139