Starting Online Operation - Siemens SINUMERIK 840Di Manual

9 Drive Start-Up (Preconditions)
9.1 SIMODRIVE 611 universal/E, POSMO CD/CA and SI
Dialog
9.1.7

Starting online operation

Start search
Display of the
drives
9-270
S
Open the hardware configuration of the station (double-click with left mouse
button on: Hardware; "HW Config" will be started)
S
Open DP master (in the example project: DP master) (double-click with left
mouse button on DP master)
S
You will find the subnetwork ID as follows using the property dialog of DP
master:
Dialog: Properties – DP Master
Tab: General
Group: Interface
Type: PROFIBUS
Address: 2
Button: "Properties..."
Dialog: Properties – PROFIBUS Interface DP Master
Tab: Parameters
Subnetwork: PROFIBUS
Button: "Properties..."
Dialog: Properties PROFIBUS
Tab: General
S7 subnetwork ID: 0010
Cancel
Cancel
Cancel.
The online operation with the drives connected to PROFIBUS can now be
started.
After parameterization of the MPI interface and entry of the routing information,
SimoCom U can enter online operation with the SIMODRIVE drives.
To start the search for any drives connected,
– quit the above mentioned dialog for setting the MPI interface using the
button: "Go online"
or
– use the menu command Start-up > Search for online drives.
The SIMODRIVE drives with which SimoCom U could start the online operation
are displayed in the SimoCom U main screen:
– Drive and dialog browser (left window)
– Status overview (upper status bar).
0005
–
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
06.03
(example)