Siemens SINUMERIK 840Di Manual page 401

06.03
Accept changes
Start-up CHAN1
Channel RESET
Settings Settings
Accepting the changes can result in the loss of NC user data.
non–volatile user memory
Ensure that these data have been stored in a series machine start-up file.
1. Memory setting have been changed.
Signal input for shutdown behavior
Changes do not become effective until after a full system reboot.
2. The shutdown behavior has been modified.
Wrong configuration results in data loss on loss of voltage.
Do you really want to make the changes now?
Diagnostics Settings
Fig. 10-39 Accepting settings
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
10.10 NC/PLC diagnosis (840Di SW 2.3 and higher)
To accept the changes made press the soft key: Accept. The message box that
appears must also be confirmed by pressing the soft key: Accept.
Use the soft key: Abort to discard all changes and display the original settings
again.
AUTO MPF0
Program aborted
2560 KB RAM / HD non–volatile
Signal source deactivated
Signal level
–
Notice
It is strongly recommended that you create a series machine start-up file as
described above prior to making any changes. See Chapter 14, page 14-449.
10 NC Start-Up with HMI Advanced
ROV
Cancel
Accept
J
10-401