10 NC Start-Up with HMI Advanced
10.5 Axes and spindles
10.5.23 Measuring systems of spindle
When parameterizing the measuring systems of spindles, the same conditions
apply as for parameterization of the measuring systems of rotary axes. This
multiple is 2048.
For incremental measuring systems, see above, Subsection 10.5.5,
For absolute measuring systems, see above, Subsection 10.5.6, page 10-320.
If the motor encoder is used for actual-value sensing, the encoder matching
data must be entered in the machine data for each individual gear stage if
several gear stages are present.
The maximum multiplication of the appropriate drive is always used as the
multiplication of the increments.
The pulse multiplication with SIMODRIVE 611 universal is 128.
Examples of encoder adaptation
Supposed the following conditions are provided:
The incremental encoder is mounted on the spindle.
Encoder pulses = 500 [pulses/rev.]
Pulse multiplication = 128
Internal precision = 1000 [increment/degree]
Encoder gear stage = 1:1
Load gear stage = 1:1
The machine data are set acc. to the values above:
MD10210: INT_INC_PER_DEG (computational resolution) = 1,000 [incr./de-
MD31020: ENC_RESOL (encoder resolution) = 500 [pulses/rev.]
MD31050: DRIVE_AX_RATION_DENOM (load rev. denominator) = 1
MD 31060: DRIVE_AX_RATION_NUMERA (load rev. numerator) = 1
MD31070: DRIVE_ENC_RATION_DENOM (load rev. denominator) = 1
MD31080: DRIVE_ENC_RATION_NUMERA (load rev. numerator) = 1
Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition