Siemens SINUMERIK 840Di Manual page 331

06.03
Machine data
Table 10-33 Parameter set-dependent machine data
Number Identifier
Axis/spindle-specific ($MA_ ...)
31050 DRIVE_AX_RATIO_DENOM[n]
31060 DRIVE_AX_RATIO_NUMERA[n]
32200 POSCTRL_GAIN[n]
32810 EQUIV_SPEEDCTRL_TIME[n]
32910 DYN_MATCH_TIME[n]
35110 GEAR_STEP_MAX_VELO[n]
35120 GEAR_STEP_MIN_VELO[n]
35130 GEAR_STEP_MAX_VELO_LIMIT[n]
35140 GEAR_STEP_MIN_VELO_LIMIT[n]
35200 GEAR_STEP_SPEEDCTRL_AC-
CEL[n]
35210 GEAR_STEP_POSCTRL_ACCEL[n]
36200 AX_VELO_LIMIT[n]
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
Parameter set no.
0
Axis interpolates
1
with spindle (G33)
Axis interpolates
2
with spindle (G33)
Axis interpolates
3
with spindle (G33)
Axis interpolates
4
with spindle (G33)
Axis interpolates
5
with spindle (G33)
Fig. 10-17 Validity of parameter sets in axis and spindle modes
The following machine data of a machine axis depend on the parameter set:
n = parameter set number (0 ... 5)
Load gear denominator
Load gear numerator
K factor
v
Equivalent time constant of speed control loop for feed-
forward control
Time constant of dynamic adaptation
Max. speed for gear stage change
Min. speed for gear stage change
Max. speed of gear stage
Min. speed of gear stage
Acceleration in speed control mode
Acceleration in position control mode
Threshold value for velocity monitoring
10 NC Start-Up with HMI Advanced
Axis Spindle
Default Axis mode
Spindle mode
Spindle mode
Spindle mode
Spindle mode
Spindle mode
Name
10.5 Axes and spindles
Spindle gear
stage
As specified by
manufacturer
1.
2nd
3rd
4th
5th
Ref.
10-331