Additional Functions - Siemens SINUMERIK 840Di Manual

Hide thumbs Also See for SINUMERIK 840Di:

Table of Contents

Additional functions

Interface signals:

Traversing enable

Fig. 13-1 Main menu: Position control loop measurement

SINUMERIK 840Di Manual (HBI) – 06.03 Edition

In conjunction with the measuring functions, another 2 axis-specific interface

signals are provided:

DB31-DBx, DBX61.0 "Drive test traversing request"

DB31-DBx, DBX1.0 "Drive test traversing enable"

In the PLC user program, this can be used in conjunction with measuring func-

tions to realize an additional axis-specific traversing enable.

The interface signals are activated from the main menu of the appropriate mea-

suring function in the group "Drive test traversing enable". See Fig. 10-37,

page 10-395.

Choose the type of traversing enable from the selection list either by using the

Toggle key or by clicking with the right mouse button on the desired enable

– Without PLC

Traversing of the axis to be measured is enabled depending on the

interface signals typical for JOG mode (servo enable, pulse enable, etc.).

13 Drive Optimization using HMI Advanced

13.3 Additional functions