Table of Contents
Advertisement
User Guidelines
This command has no user guidelines.
Example
The following example displays OSPF interface VLAN information.
console#show ipv6 ospf interface vlan 10
IPv6 Address............................. FE80::2FC:E3FF:FE90:44
ifIndex.................................. 634
OSPF Admin Mode.......................... Enable
OSPF Area ID............................. 0.0.0.1
Router Priority.......................... 1
Retransmit Interval...................... 5
Hello Interval........................... 10
Dead Interval............................ 40
LSA Ack Interval......................... 1
Iftransit Delay Interval................. 1
Authentication Type...................... None
Metric Cost.............................. 10
OSPF Mtu-ignore.......................... Disable
OSPF Interface Type...................... broadcast
State.................................... backup-designated-router
Designated Router........................ 1.1.1.1
Backup Designated Router................. 2.2.2.2
Number of Link Events.................... 46
show ipv6 ospf neighbor
Use the show ipv6 ospf neighbor command to display information about
OSPF neighbors. If a neighbor IP address is not specified, the output displays
summary information in a table. If an interface or tunnel is specified, only the
information for that interface or tunnel displays. The information below only
displays if OSPF is enabled and the interface has a neighbor.
Syntax
show ipv6 ospf neighbor [interface-type interface-number] [neighbor-id]
•
interface-type—Interface type, vlan or tunnel.
•
interface-number—A valid interface number, a valid VLAN ID or tunnel
identifier. (Range is 0-7).
•
neighbor-id—Valid IP address of the neighbor about which information is
displayed.
(computed)
Layer 3 Routing Commands
1763
Advertisement
Table of Contents
