Rear Master Cylinder Installation; Front Brake Caliper Removal; Front Brake Caliper Disassembly - Honda 2010 CRF250R Service Manual

HYDRAULIC BRAKE
INSTALLATION
Inslall the master cylinder and mounting bolts.
Tighten the master cylinder mounting bolts to the
specified torque
TORQUE : 13 N'm (1.3 kgf-m, 10 IbHt)
Inslall the brake hose eyelet wi th the brake hose oil bolt
~~~~§~=~~~~~~~~~~~~
and new sealing washers.
I
Push the brake hose eyelet joint against the stopper,
then lighten the brake hose oil bolt to the specified
torque.
TORQUE : 34 N'm (3.5 kgf'm , 25 IbHt)
Install the brake pedal (page 15-29).
Fill the reservoir to the upper level, and bleed the brake
system (page 15-8).
FRONT BRAKE CALIPER
REMOVAL
15-22
Drain the front brake hydraulic system (page 15-7).
Remove the brake hose oil
bolt,
sealing washers and
brake hose eyelet.
Remove the brake pads (page 15-11).
DISASSEMBLY
Remove the caliper bracket from the brake caliper.
Remove the brake pad spring from the caliper.
Remove the brake pad retainer from the caliper
bracket.
Remove the caliper pin boot and bracket pin boot.
BRACKET RETAINER BOOTS
PAD