Copy Function Related Displays; Copy Function Related Displays; Tasks, Errors, And Troubleshooting - YASKAWA L1000V Technical Manual

6.7

Copy Function Related Displays

u Tasks, Errors, and Troubleshooting
The table below lists the messages and errors that may appear when using the Copy function.
When executing the tasks offered by the Copy function, the operator will indicate the task being performed. When an
error occurs, a code appears on the operator to indicate the error. Note that errors related to the Copy function do not
trigger a multi-function output terminal that has been set up to close when a fault or alarm occurs. To clear an error,
simply press any key on the operator and the error display will disappear.
Table 6.11 lists the corrective action that can be taken when an error occurs.
Note: 1. Whenever using the copy function, the drive should be fully stopped.
2. The drive will not accept an Up/Down command while the Copy function is being executed.
3. Parameters can only be saved to a drive when the voltage class, capacity, control mode, and software version match.
Digital Operator Display
Cause
Parameters are being written to the drive.
Digital Operator Display
Cause
Control mode of the parameters to be loaded onto the drive
and the control mode already set to the drive don't match.
Digital Operator Display
Cause
Failed writing parameters.
Digital Operator Display
Cause
Hardware fault
Digital Operator Display
Cause
• The drives used in the copy and write process are not the
same model.
• The drive from which the parameters were copied is a
different model.
• The drive to be written to is a different model.
Digital Operator Display
Cause
Finished reading, writing, or verifying parameters.
Digital Operator Display
Cause
A communication error occurred between the drive and the
operator or the USB copy unit.
A non-compatible cable is being used to connect the USB
Copy Unit and the drive.
Digital Operator Display
Cause
The drive from which the parameters were copied and the
drive to which you are attempting to write have different
electrical specifications, capacities, are set to different
control modes, or are different models.
The device being used to write the parameters is blank and
does not have any parameters saved on it.
YASKAWA EUROPE SIEP
Table 6.11 Copy Function Task and Error Displays
CoPy Writing Parameter Settings (flashing)
Not an error.
CPEr Control Mode Mismatch
Check the control mode for the parameters that are to be loaded onto the drive and the control mode set to the drive
those parameters will be written to. Set the same control mode using parameter A1-02 and try again.
CPyE Error Writing Data
Try writing parameters again.
CSEr Copy Unit Error
Replace the operator or the USB Copy Unit.
dFPS Drive Model Mismatch
Check the model number of the drive from which the parameters were copied and the model of the drive to which you
are attempting to write the parameters. Make sure the two drives are the same model and have the same software
version.
End Task Complete
Not an error.
iFEr Communication Error
Check the cable connection.
Use the cable originally packaged with the USB Copy Unit.
ndAT Model, Voltage Class, Capacity Mismatch
Make sure model numbers and specifications are the same for both drives.
Making sure all connections are correct, and copy the parameter settings onto the USB Copy Unit or the operator.
YASKAWA AC Drive L1000V Technical Manual

6.7 Copy Function Related Displays

Task
Possible Solutions
Task
Possible Solutions
Task
Possible Solutions
Task
Possible Solutions
Task
Possible Solutions
Task
Possible Solutions
Task
Possible Solutions
Task
Possible Solutions
6
185