YASKAWA L1000V Technical Manual page 34

2.2 Mechanical Installation
Installation Method
Simplified installation with the digital
External/Face-Mount operator mounted on the outside of
the panel with two screws.
Encloses the digital operator in the
Internal/Flush-Mount panel. The digital operator is flush
with the outside of the panel.
NOTICE: Prevent foreign matter such as metal shavings or wire clippings from falling into the drive during installation and project
construction. Failure to comply could result in damage to the drive. Place a temporary cover over the top of the drive during
installation. Remove the temporary cover before drive start-up, as the cover will reduce ventilation and cause the drive to overheat.
External/Face-Mount
Cut an opening in the enclosure panel for the digital operator as shown in
1.
Position the digital operator so the display faces outwards, and mount it to the enclosure panel as shown in
2.
Figure 2.6.
Figure 2.5
Figure 2.6
34
Table 2.2 Digital Operator Installation Methods and Required Tools
Description Installation Support Sets
(for mounting with screws through
(for use with threaded studs that are
Digital Operator
Figure 2.6 External/Face-Mount Installation
Figure 2.7 Panel Cut-Out Dimensions (External/Face-Mount Installation)
YASKAWA EUROPE SIEP
–
Installation Support Set A
holes in the panel)
Installation Support Set B
fixed to the panel)
M3 × 6
Phillips recessed
pan head machine screw × 2
Enclosure panel
22
22
14
Model
– Phillips screwdriver (#1)
EZZ020642A Phillips screwdriver (#1, #2)
Phillips screwdriver (#1)
EZZ020642B
Figure 2.7.
common_TMonly
Unit: mm
common_TMonly
Unit: mm
YASKAWA AC Drive L1000V Technical Manual
Required Tools
Wrench (7 mm)