Settings For Status:preset - Agilent Technologies 8712ET Programmer's Manual

Table 5-1
STATus:DEVice
STATus:QUEStionable:LIMit
STATus:QUEStionable
STATus:OPERation:MEASuring
STATus:OPERation:AVERaging
STATus:OPERation

Settings for STATus:PRESet

Executing the STATus:PRESet command changes the settings in the
enable (ENAB), positive transition (PTR), and negative transition (NTR)
registers. The table below shows the settings after the command is
executed.
Status Register States After PRESet Command
Register Set
Programmer's Guide
The Analyzer's Status Register Sets
ENABle PTRansition
all 0s all 1s
all 1s all 1s
all 0s all 1s
all 1s all 0s
all 1s all 0s
all 0s all 1s
Using Status Registers
NTRansition
all 0s
all 0s
all 0s
all 1s
all 1s
all 0s
5-25