Agilent Technologies 8712ET Programmer's Manual page 242

Table 11-19
SUBSYSTEM COMMANDS
SENSe[1|2]:CORRection:COLLect
:MP:LOAD
<STAN1|STAN2|...|STAN12>
SENSe[1|2]:CORRection:COLLect
:MP:THRU
<STAN1|STAN2|...|STAN6>
SENSe[1|2]:CORRection:COLLect
:PORTS <2|4|6|8|10|12>
SENSe[1|2]:CORRection:COLLect
:SAVE
SENSe[1|2]:CORRection:COLLect
:VERify:REFLection
<STAN1|STAN2|...|STAN12>
SENSe[1|2]:CORRection:COLLect
:VERify:TRANsmission
<STAN1|STAN2|...|STAN12>;
SENSe[1|2]:CORRection:CSET
[:SELect] DEFault
SENSe[1|2]:CORRection:CSET
[:SELect]?
SENSe[1|2]:CORRection:EDELay
2
:TIME <num>
SENSe[1|2]:CORRection:EXTensi
on:REFLection[:TIME]<num>
1. For use with multiport test sets only.
2. Numeric parameters may include an appropriate suffix; if no suffix is included, the
default (HZ for frequency or S for time) is assumed.
SCPI Command Summary
SCPI Device Command Summary
SENSe (7 of 16)
2
11-44
FORM
command Measures a load on the port selected
only
during a test set calibration.
command Measures a thru on the port selected
only
during a test set calibration.
NR1 Selects the number of ports to
perform a test set calibration on.
command Completes and saves current
only calibration.
command Measures a calibration standard
only during a cal check procedure for
reflection measurements.
command Measures a calibration standard
only during a cal check procedure for
transmission measurements.
command Restores the "factory" default
only calibration for the current
measurement and channel.
query only Queries the current calibration type
CHAR — returns DEF (factory default),
FULL (full band) or USER (user
defined).
NR3 Specifies the electrical delay in
seconds.
NR3 Specifies the port extension at the
reflection port, in seconds.
DESCRIPTION
2
2
Programmer's Guide
1