Agilent Technologies 8712ET Programmer's Manual page 231

Table 11-14
SUBSYSTEM COMMANDS
MMEMory:STORe:STATe:TSCAL
1
<ON|OFF>
MMEMory:STORe:TRACe
<char>,<string>
MMEMory:STORe:TRACe:FORMat
<char>
MMEMory:TRANsfer:BDAT
2
<string> [,<block>]
MMEMory:TRANsfer[:HFS]
2
<string> [,<block>]
1. Binary parameters accept the values of 1 (on) and 0 (off) in addition to ON and OFF.
2. File names may include the mass storage device name—MEM:( internal non-volatile
memory), RAM: (internal volatile memory), INT: (internal 3.5" disk drive), or NFS
local path. Wildcards ? and * may be used.
3. Refer to "Automated Measurement and Control" in Chapter 7 of the User's Guide for
more information on using this command
4. Refer to the Example Programs Guide for more information on using this command.
5. Refer to the example programs PUTFILE and GETFILE in the Example Programs
Guide.
MMEMory (3 of 3)
2, 3
4
4
Programmer's Guide
SCPI Device Command Summary
FORM
NR1 When on, the saved state will be
the test set cal only.
command Stores an ASCII list of trace and
only frequency values to a file — char
is the formatted data trace
CH<1|2>FDATA and string is
the filename.
CHAR Selects the format that the ASCII
data will be saved in. Choose
from LOTus 123 or TOUChstone.
STRING, Copies a file to or from the
BLOCK analyzer's disk drive.
STRING, Copies a file to or from the
analyzer's disk drive.
SCPI Command Summary
DESCRIPTION
5
5
11-33