Agilent Technologies 8712ET Programmer's Manual page 203

Table 11-2
SUBSYSTEM
COMMANDS
CALCulate[1|2]:DATA?
CALCulate[1|2]:FORMat
<char>
CALCulate[1|2]:FORMat
:UNIT:MLIN <char>
CALCulate[1|2]:FORMat
:UNIT:MLOG <char>
CALCulate[1|2]
:GDAPerture:APERture
<num>
CALCulate[1|2]
:GDAPerture:SPAN <num>
1. Refer to Chapter
example programs in the Example Programs Guide for more information on this
command.
2. The parameter type of the data is determined by the format selected — FORMat
REAL uses BLOCK data, FORMat ASCii uses NR3 data separated by commas.
CALCulate (1 of 7)
FORM
1
query only
BLOCK
2
or NR3
CHAR
CHAR
CHAR
NR3
NR3
6, "Trace Data Transfers," and to the ASCDATA and REALDATA
Programmer's Guide
SCPI Device Command Summary
DESCRIPTION
Queries the formatted data trace —
functionally equivalent to the command
TRAC? CH<1|2>FDATA.
Selects the display format for measurement
data — choose from MLOGarithmic|
MLINear|SWR or PHASe|SMITh|POLar|
GDELay|REAL|IMAGinary|MIMPedance.
Selects linear magnitude units for Y-axis
display. Choose from W|MW|UW|V|MV|UV.
Selects log magnitude units for Y-axis display.
Choose from
DBW|DBM|DBUW|DBV|DBMV|DBUV.
Sets the group delay aperture as a ratio of
desired aperture / measured frequency span.
Specifies the group delay aperture in Hertz.
SCPI Command Summary
11-5