Agilent Technologies 8712ET Programmer's Manual page 255

Table 11-21
SUBSYSTEM COMMANDS
STATus:OPERation:NTRansition
<num>
STATus:OPERation:PTRansition
<num>
STATus:PRESet
STATus:QUEStionable:CONDition?
STATus:QUEStionable:ENABle <num>
STATus:QUEStionable[:EVENt]?
STATus:QUEStionable:LIMit
:CONDition?
1. <num> is the sum of the decimal weights of all bits to be set.
2. Returns the sum of the decimal weights (2
currently set. For more information on using the status registers refer to
"Using Status Registers."
STATus (3 of 4)
Programmer's Guide
FORM
NR1 Sets and queries bits in the
Operational Status negative
transition register.
NR1 Sets and queries bits in the
Operational Status positive
transition register.
command Sets bits in most enable and
only transition registers to their
default state.
query only Reads the Questionable Status
NR1 condition register.
NR1 Sets and queries bits in the
Questionable Status enable
register.
query only Reads and clears the
NR1 Questionable Status event
register.
query only Reads the Limit Fail condition
NR1
register.
n
where n is the bit number) of all bits
SCPI Command Summary
SCPI Device Command Summary
DESCRIPTION
1
1
2
1
2
2
Chapter 5,
11-57