Agilent Technologies 8712ET Programmer's Manual page 208

Table 11-2
SUBSYSTEM COMMANDS
CALCulate[1|2]:MARKer
[1|2|8]:MAXimum:RIGHt
CALCulate[1|2]:MARKer
[1|2|8]:MINimum
CALCulate[1|2]:MARKer
[1|2|8]:MINimum:LEFT
CALCulate[1|2]:MARKer
[1|2|8]:MINimum:RIGHt
CALCulate[1|2]:MARKer
:MODE <char>
CALCulate[1|2]:MARKer
3
:NOTCh <num>
CALCulate[1|2]
:MARKer[1|2|8]:POINt
CALCulate[1|2]
:MARKer:REFerence:X?
CALCulate[1|2]
:MARKer:REFerence:Y?
CALCulate[1|2]
:MARKer[1|2|8][:STATe]
2
<ON|OFF>
CALCulate[1|2]
:MARKer[1|2|8]:TARGet
3
<char>,<num>
1. Refer to "Displaying Measurement Results" in Chapter 7 of the User's Guide for
more information on using this command.
2. Binary parameters accept the values of 1 (on) and 0 (off) in addition to ON and
OFF.
3. Numeric parameters may include an appropriate suffix; if no suffix is included, the
default (HZ for frequency or S for time) is assumed.
SCPI Command Summary
SCPI Device Command Summary
CALCulate (6 of 7)
command
only
command
only
command
only
command
only
CHAR
NR3
NR3
1
query
only NR3
query
only NR3
NR1
CHAR,
NR3
11-10
FORM
Moves the specified marker to the next
local maximum to the right.
Sets the specified marker to the
minimum value on the trace.
Moves the specified marker to the next
local minimum to the left.
Moves the specified marker to the next
local minimum to the right.
Turns delta marker state on/off —
choose ABSolute or RELative.
Calculates the notch width of a notch
filter — num is the marker search level
(−6 for the default 6 dB bandwidth).
Sets the specified marker point.
Queries the frequency of the reference
marker.
Queries the amplitude of the reference
marker.
Turns the specified marker on/off.
Performs a marker search for a target
value — char is the direction LEFT or
RIGHt.
DESCRIPTION
Programmer's Guide