Agilent Technologies 8712ET Programmer's Manual page 256

Table 11-21
SUBSYSTEM COMMANDS
STATus:QUEStionable:LIMit:
ENABle <num>
STATus:QUEStionable:LIMit
[:EVENt]?
STATus:QUEStionable:LIMit
:NTRansition <num>
STATus:QUEStionable:LIMit
:PTRansition <num>
STATus:QUEStionable:NTRansition
<num>
STATus:QUEStionable:PTRansition
<num>
1. <num> is the sum of the decimal weights of all bits to be set.
2. Returns the sum of the decimal weights (2
currently set. For more information on using the status registers refer to
"Using Status Registers."
SCPI Command Summary
SCPI Device Command Summary
STATus (4 of 4)
11-58
FORM
NR1 Sets and queries bits in the Limit
Fail enable register.
query only Reads and clears the Limit Fail
NR1 event register.
NR1 Sets and queries bits in the Limit
Fail negative transition register.
NR1 Sets and queries bits in the Limit
Fail positive transition register.
NR1 Sets and queries bits in the
Questionable Status negative
transition register.
NR1 Sets and queries bits in the
Questionable Status positive
transition register.
n
where n is the bit number) of all bits
DESCRIPTION
1
2
1
1
Chapter 5,
Programmer's Guide
1
1