Agilent Technologies 8712ET Programmer's Manual page 250

Table 11-19
SUBSYSTEM COMMANDS
SENSe[1|2]:FUNCtion:SRL
1
:<num>,<num>
SENSe[1|2]:FUNCtion:SRL
:IMPedance <num>
SENSe[1|2]:FUNCtion:SRL
:MODE <char>
SENSe[1|2]:FUNCtion:SRL
:SCAN[:IMMediate]
SENSe[1|2]:ROSCillator
:SOURce <char>
SENSe[1|2]:STATe <ON|OFF>
1. Numeric parameters may include an appropriate suffix; if no suffix is included, the
default (HZ for frequency or S for time) is assumed.
2. For use with structural return loss measurements on analyzers with Option 100
only.
3. Binary parameters accept the values of 1 (on) and 0 (off) in addition to ON and OFF.
SCPI Command Summary
SCPI Device Command Summary
SENSe (15 of 16)
NR1,NR1
NR2
1
CHAR
command
only
CHAR
3
NR1
11-52
FORM
Specifies that the receiver will
measure the ratio of the power (SRL)
into the specified measurement
2
channel
For 8712ET/8714ET models—choose
1,0 (Forward A/R).
For 8712ES/8714ES models—choose
1,0 (Forward A/R), or 22, 20 (Reverse
B/R).
Sets the cable impedance.
Sets the auto z function to AUTO or
MANual.
Starts a cable scan.
Specifies the source of the reference
oscillator — select INTernal or
EXTernal.
Turns the specified channel on/off .
DESCRIPTION
.
2
2
2
Programmer's Guide