Agilent Technologies 8712ET Programmer's Manual page 151

Table 10-8
KEYSTROKES
(SRL)
CAL,
Default Cal
Full Band Cal
Measure Standard 1
Connector Model
Measure Connector
Measure
Connector Length
Connector C
Z cutoff Frequency
Auto Z ON off
Manual Z
Connector Fault
Cal Check
(see Table 10-10 on page
More Cal
(see Table 10-11 on page
1. Pressing this key begins a guided calibration procedure using three standards.
When the calibration is complete, the command
*WAI;:SENS[1|2]:CORR:COLL:SAVE;*WAI is executed.
Functions, 8712ET/ES and 8714ET/ES
SENS[1|2]:CORR:CSET DEF; *WAI
SENS[1|2]:CORR:EXT [ON|OFF]
SENS[1|2]:CORR:COLL STAN[1|2|3];*WAI
(menu selection only)
(menu selection only)
SENS[1|2]:CORR:MODEL:CONN
SENS[1|2]:CORR:LENG:CONN <num>
SENS[1|2]:CORR:CAP:CONN <num>
SENS:FREQ:ZST <num>
SENS[1|2]:FUNC:SRL:MODE [MANUAL|AUTO]
SENS[1|2]:FUNC:SRL:IMP <num>
(sets instrument to connector fault display)
(menu selection only)
10-25)
(menu selection only)
10-26)
Programmer's Guide
Menu Map with SCPI Commands
Menu Map for 8712ET/ES and 8714ET/ES
SCPI COMMAND
10-23