Agilent Technologies 8712ET Programmer's Manual page 159

Table 10-12
KEYSTROKES
1
DISPLAY
Normalize
Data ->Mem
Data
Memory
Data/Mem
Data and Memory
2
Limit Menu
Add Limit
Add Max Line
Begin Frequency
End Frequency
Begin Limit
End Limit
Marker
1. The active measurement channel configuration determines the order of appearance
and the content of the softkey menus.
2. Limit Menu choices are provided based on the current measurement channel config-
uration. If the instrument is configured for fault location measurements, the limit
values are distances, for example.
3. Limit segments are numbered by the instrument as they are entered. At the same
time the Limit menu is displayed, the currently defined limits are displayed.
Functions, 8712ET/ES and 8714ET/ES (1 of 5)
DISPLAY
(hardkey entry)
TRAC CH[1|2]SMEM,CH[1|2]SDATA;:
CALC[1|2]:MATH (IMPL/CH[1|2]SMEM);:
DISP: WIND[1|2]:TRAC1 ON;TRAC2 OFF
TRAC CH[1|2]SMEM,CH[1|2]SDATA
CALC[1|2]:MATH (IMPL);:DISP:
WIND[1|2]:TRAC1 ON;TRAC2 OFF
DISP:WIND[1|2]:TRAC1 OFF;TRAC2 ON
CALC[1|2]:MATH (IMPL/CH[1|2]SMEM);:
DISP:WIND[1|2]:TRAC1 ON;TRAC2 OFF
CALC[1|2]:MATH
(IMPL);:DISP:WIND[1|2]:TRAC1 ON;TRAC2 ON
CALC[1|2]:LIM:DISP ON
(menu selection only)
CALC[1|2]:LIM:SEGM[n]:TYPE LMAX;STAT ON
CALC[1|2]:LIM:SEGM[n]:FREQ:STAR <num> HZ
CALC[1|2]:LIM:SEGM[n]:FREQ:STOP <num> HZ
CALC[1|2]:LIM:SEGM[n]:AMPL:STAR <num>
CALC[1|2]:LIM:SEGM[n]:AMPL:STOP <num>
CALC[1|2]:MARK1:X <num>
Programmer's Guide
Menu Map with SCPI Commands
Menu Map for 8712ET/ES and 8714ET/ES
SCPI COMMAND
3
10-31