Agilent Technologies 8712ET Programmer's Manual page 212

Table 11-5
SUBSYSTEM COMMANDS
CONTrol[1|2]:MULTiport
:STATE <ON|OFF>
1. For use with multiport test sets only.
Table 11-6
SUBSYSTEM COMMANDS
DIAGnostic:CCONstants:INSTalled?
DIAGnostic:CCONstants:LOAD
DIAGnostic:CCONstants:STORE:DISK
DIAGnostic:CCONstants:STORE
:EEPRom
DIAGnostic:COMMunicate:LAN
:NETWork:STAT
DIAGnostic:COMMunicate:LAN:PING
:IMM
DIAGnostic:COMMunicate:LAN:PING
:IPAD <string>
SCPI Command Summary
SCPI Device Command Summary
CONTrol
FORM
NR1
DIAGnostic (1 of 4)
11-14
DESCRIPTION
When on, configures analyzer for use with a
1
multiport test set.
FORM
query Queries if correction constants
only NR1 are installed in flash. Returns a 1
if true, and a 0 if false.
command Loads default factory calibration
only constants from floppy disk to
memory.
command Stores default factory calibration
only constants from memory to floppy
disk.
command Stores default factory calibration
only constants from memory to flash
EEPROM.
command Displays the menu to set the IP
only address to ping and to perform
ping.
command "Pings" a remote user-specified
only IP address. Used in
troubleshooting or verifying a
LAN connection.
STRING Sets the IP address to ping.
DESCRIPTION
Programmer's Guide