Agilent Technologies 8712ET Programmer's Manual page 130

NOTE
NOTE
Menu Map with SCPI Commands
This chapter shows all softkey menu choices available. Each hardkey on
the instrument front panel has a corresponding table in this chapter
showing all softkey choices available after pressing the hardkey.
Hardkeys and softkeys are shown as
Each softkey is shown with an associated SCPI command, if one exists.
SCPI commands are shown as the short form.
The configuration of the currently active measurement channel
determines the order of appearance and the content of the softkey menus.
Command Conventions
Commands requiring a choice of measurement channel are shown with
both choices:
SENS[1|2]:
appropriate channel given:
chosen).
Parameter Types
<num> and <string> refer to parameter types described in the
"Parameter Types" section. <string> parameters are enclosed in single
quotes: 'the string data'. <value> parameters include <num> and
an optional <unit>.
Softkey Menus
Most softkey choices and associated SCPI commands are shown in the
following Menu Map tables. Because the analyzer provides great
flexibility in measurement configuration, and because many softkey
menus and user operations are very similar to each other, not every
variation of each softkey menu is shown.
SCPI commands that are associated with menu selections can be found
by reading the program that is created after keystroke recording has
been enabled and the desired keys have been pressed.
Refer to the Hardkey/Softkey Reference in your instrument's User's
Guide for a description of each key.
10-2
HARDKEY
(for example). The command is entered with the
(channel 1 chosen) or
SENS1:
and .
Soft Key
(channel 2
SENS2:
Programmer's Guide