Agilent Technologies 8712ET Programmer's Manual page 65

Operation Complete
(bit 0) is set to one when the following two events occur (in
the order listed):
1. The *OPC command is sent to the analyzer.
2. The analyzer completes all pending overlapped
Request Control
(bit 1) is set to 1 when both of the following conditions are
true:
• The analyzer is configured as a talker/listener for
• The analyzer is instructed to do something (such as
Query Error
(bit 2) is set when the command parser detects a query
error. A query error indicates that one or both of the
following actions occurred:
• an attempt to read data from the Output Queue
• that data in the Output Queue was lost. An example
Device Dependent Error
(bit 3) is set to 1 when the command parser detects a
device-dependent error. A device-dependent error is any
analyzer operation that did not execute properly due to
some internal condition such as overrange. This bit
indicates that the error was not a command, query, or an
execution error.
Programmer's Guide
commands.
GPIB operation.
plotting or printing) that requires it to take control
of the bus.
when no data was present.
of this would be queue overflow.
Using Status Registers
The Analyzer's Status Register Sets
5-21