Agilent Technologies 8712ET Programmer's Manual page 249

Table 11-19
SUBSYSTEM COMMANDS
SENSe[1|2]:FUNCtion
'XFRequency:S <num>,<num>'
SENSe[1|2]:FUNCtion:FAULt
:CONNector [:IMMediate]
1. For use with the 8712ES and 8714ES models only.
SENSe (14 of 16)
FORM
NR1,NR1
command
only
Programmer's Guide
SCPI Device Command Summary
DESCRIPTION
Specifies that the receiver will measure
an s-parameter into the specified
measurement channel. The s-parameter
choices will depend on the number of
ports. For example, with a 2-port device,
choose from 1,1 (S
11
(S ), or 2,1 (S ).
22 21
As another example, with a 12-port
device using the 87075C multiport test
set, some choices would include 1,8
(S ), or 12,1 (S ,
18 1
12
This command may be used in place of:
SENS[1|2]:FUNC 'XFR:POW:RAT
and ROUT[1|2}:PATH:DEF:PORT.
If using the 87075C multiport test set,
this command may be used in place of
the two commands just listed, as well as:
ROUT[1|2]:REFL:PATH:DEF:PORT
and
OUT[1|2]:TRAN:PATH:DEF:PORT.
Forces a connector verification
measurement on the alternate channel.
(For use with SRL measurements on
analyzers with Option 100 only.)
SCPI Command Summary
), 1,2 (S ), 2,2
12
), or 7,7 (S ).
77
1
11-51