Agilent Technologies 8712ET Programmer's Manual page 254

Table 11-21
SUBSYSTEM COMMANDS
STATus:OPERation:AVERaging
:PTRansition <num>
STATus:OPERation:CONDition?
STATus:OPERation:ENABle
<num>
STATus:OPERation[:EVENt]?
STATus:OPERation:MEASuring
:CONDition?
STATus:OPERation:MEASuring
:ENABle <num>
STATus:OPERation:MEASuring
[:EVENt]?
STATus:OPERation:MEASuring
:NTRansition <num>
STATus:OPERation:MEASuring
:PTRansition <num>
1. <num> is the sum of the decimal weights of all bits to be set.
2. Returns the sum of the decimal weights (2
currently set. For more information on using the status registers refer to
5, "Using Status Registers."
SCPI Command Summary
SCPI Device Command Summary
STATus (2 of 4)
11-56
FORM
NR1 Sets and queries bits in the
Averaging status positive transition
register.
query only Reads the Operational status
NR1 condition register.
NR1 Sets and queries bits in the
Operational status enable register.
query only Reads and clears the Operational
NR1
status event register.
query only Reads the Measuring status
NR1
condition register.
NR1 Sets and queries bits in the
Measuring status enable register.
query only Reads and clears the Measuring
NR1
status event register.
NR1 Sets and queries bits in the
Measuring status negative
transition register.
NR1 Sets and queries bits in the
Measuring status positive
transition register.
n
where n is the bit number) of all bits
DESCRIPTION
1
2
2
2
2
1
1
Chapter
Programmer's Guide
1
1