Agilent Technologies 8712ET Programmer's Manual page 206

Table 11-2
SUBSYSTEM COMMANDS
CALCulate[1|2]:LIMit:SEGMent
[1|2|12]:FREQuency:STOP
2
<num>
CALCulate[1|2]:LIMit:SEGMent
[1|2|12]:POWer:STARt
2
<num>
CALCulate[1|2]:LIMit:SEGMent
[1|2|12]:POWer:STOP
2
<num>
CALCulate[1|2]:LIMit:SEGMent
[1|2|12]:STATe
1
<ON|OFF>
CALCulate[1|2]:LIMit:SEGMent
[1|2|12]:TYPE
<char>
CALCulate[1|2]:LIMit:STATe
1
<ON|OFF>
CALCulate[1|2]:MARKer:AOFF
CALCulate[1|2]:MARKer:BWIDth
2
<num>
1. Binary parameters accept the values of 1 (on) and 0 (off) in addition to ON and OFF.
2. Numeric parameters may include an appropriate suffix; if no suffix is included, the
default (HZ for frequency or S for time) is assumed.
SCPI Command Summary
SCPI Device Command Summary
CALCulate (4 of 7)
NR3
NR3
NR3
NR1
CHAR
NR1
command
NR3
11-8
FORM
Sets the End Frequency for the
specified limit segment.
Sets the Begin Power for the specified
limit segment.
Sets the End Power for the specified
limit segment.
Turns the specified limit segment on/off
— adds or deletes the segment.
Sets the limit type for the specified
segment, choose from
LMAX|LMIN|PMAX|PMIN (Max Line,
Min Line, Max Point, Min Point) — sets
all of the segment's limit parameters to
their default values.
Turns the limit test on/off.
Turns off all markers for a given
only channel — this has the effect of turning
off marker functions and tracking as
well.
Calculates the bandwidth of a
bandpass filter — num is the target
bandwidth
(−3 for the 3 dB bandwidth).
DESCRIPTION
Programmer's Guide