Agilent Technologies 8712ET Programmer's Manual page 219

Table 11-9
SUBSYSTEM COMMANDS
DISPlay:ANNotation:FREQuency
[1|2]:USER:STARt<num>
DISPlay:ANNotation:FREQuency
[1|2]:USER:STATe[OFF|ON]
DISPlay:ANNotation:FREQuency
[1|2]:USER:STOP<num>
DISPlay:ANNotation:FREQuency
[1|2]:USER:SUFFix[:DATA]
2
<string>
DISPlay:ANNotation:LIMit:ICON
[1|2]:FLAG[:STATe] <ON|OFF>
DISPlay:ANNotation:LIMit:ICON
[1|2] :POSition:X <num>
DISPlay:ANNotation:LIMit:ICON
[1|2] :POSition:Y <num>
DISPlay:ANNotation:LIMit:ICON
[1|2] :TEXT[:STATe] <ON|OFF>
DISPlay:ANNotation:MARKer[1|2]
:NUMBers [:STATe] <OFF|ON>
DISPlay:ANNotation:MARKer[1|2]
[:STATe]<ON|OFF>
1. Binary parameters accept the values of 1 (on) and 0 (off) in addition to ON and OFF.
2. Refer to "Displaying Measurement Results" in Chapter 7 of the User's Guide for
more information on using this command.
DISPlay (2 of 7)
2
1,2
2
1
1
1
1
Programmer's Guide
FORM
NR3 Specifies the start value for
user-defined frequency annotation.
NR1 Enables user-defined frequency
annotation.
NR3 Specifies the stop value for
user-defined frequency annotation.
STRING Specifies the suffix for user defined
frequency annotation.
NR1 Enables/disables the display of the
limit test fail icon.
NR1 Positions the limit test pass/fail text
and icon on the display. Accepts
whole number values from 0 (flush
left) to 100 (flush right).
NR1 Positions the limit test pass/fail text
and icon on the display. Accepts
whole number values from 0 (bottom
of display) to 100 (top of display).
NR1 Turns the limit test "PASS/FAIL"
text on or off.
NR1 Enables/disables the display of
marker numbers on trace markers.
NR1 Enables/disables the active marker
annotation for measurement
channels 1 and 2.
SCPI Command Summary
SCPI Device Command Summary
DESCRIPTION
11-21