Agilent Technologies 8712ET Programmer's Manual page 243

Table 11-19
SUBSYSTEM COMMANDS
SENSe[1|2]:CORRection:EXTension[:
STATe]<ON|OFF>
SENSe[1|2]:CORRection:EXTension
:TRANsmission[:TIME] <num>
SENSe[1|2]:CORRection:IMPedance
:INPut:MAGNitude<num>
SENSe[1|2]:CORRection:IMPedance
:INPut:MAGNitude:SELect ZO_50
SENSe[1|2]:CORRection:IMPedance
:INPut:MAGNitude:SELect ZO_75
SENSe[1|2]:CORRection:ISOLation
[:STATe] {OFF|0|ON|1}
SENSe[1|2]:CORRection:LENGth
2
:COAX <num>
SENSe[1|2]:CORRection:LENGth
:CONNector <num>
SENSe[1|2]:CORRection:LOSS
2
:COAX <num>
1. Binary parameters accept the values of 1 (on) and 0 (off) in addition to ON and OFF.
2. Numeric parameters may include an appropriate suffix; if no suffix is included, the
default (HZ for frequency or S for time) is used.
3. For use with structural return loss measurements using analyzers with Option 100
only.
SENSe (8 of 16)
1
2
2
2
Programmer's Guide
SCPI Device Command Summary
FORM
NR1 Enables port extensions.
NR3 Specifies the port extension at
the transmission port, in
seconds.
NR3 Specifies the reference
impedance for the Smith chart
display. The default is the
analyzer's system impedance.
NR1 Selects 50 ohms as the system
impedance.
NR1 Selects 75 ohms as the system
impedance.
NR1 Enables or disables use of
isolation error correction when
2-port calibrations are selected.
NR2 Specifies the length of cable to
be calibrated, in feet or
meters.
NR2 Specifies the length of an
interface connector, in mm or
inches.
NR2 Specifies the loss of a cable
under test, in dB/100 ft.
SCPI Command Summary
DESCRIPTION
3
3
3
11-45