Agilent Technologies 8712ET Programmer's Manual page 205

Table 11-2
SUBSYSTEM COMMANDS
CALCulate[1|2]:LIMit:MARKer
:STATistic:PEAK:STATe
1
<ON|OFF>
CALCulate[1|2]:LIMit:MARKer
:TILT:MAXimum <num>
CALCulate[1|2]:LIMit:MARKer
:TILT:MINimum <num>
CALCulate[1|2]:LIMit:MARKer
:TILT [:STATe] <ON|OFF>
CALCulate[1|2]:LIMit:SEGMent
[1|2|12]:AMPLitude:STARt
2
<num>
CALCulate[1|2]:LIMit:SEGMent
[1|2|12]:AMPLitude:STOP
2
<num>
CALCulate[1|2]:LIMit:SEGMent
:AOFF
CALCulate[1|2]:LIMit:SEGMent
[1|2|12]:DISTance:STARt
2
<num>
CALCulate[1|2]:LIMit:SEGMent
[1|2|12]:DISTance:STOP <num>
CALCulate[1|2]:LIMit:SEGMent
[1|2|12]:FREQuency:STARt
2
<num>
1. Binary parameters accept the values of 1 (on) and 0 (off) in addition to ON and OFF.
2. Numeric parameters may include an appropriate suffix; if no suffix is included, the
default (HZ for frequency or S for time) is assumed.
CALCulate (3 of 7)
2
2
1
2
Programmer's Guide
FORM
NR1 Turns statistic peak-to-peak marker
limit test on/off.
NR3 Sets the maximum value for delta
amplitude marker limit test.
NR3 Sets the minimum value for delta
amplitude marker limit test.
NR1 Turns delta amplitude marker limit
testing on or off.
NR3 Sets the Begin Limit for the specified
limit segment.
NR3 Sets the End Limit for the specified
limit segment.
command Turns off all limit segments for a
only given channel — deletes all segments
in the channel's limit table.
NR3 Sets the Begin Distance for the
specified limit segment.
(Option 100 only)
NR3 Sets the End Distance for the
specified limit segment.
(Option 100 only)
NR3 Sets the Begin Frequency for the
specified limit segment.
SCPI Command Summary
SCPI Device Command Summary
DESCRIPTION
11-7