Preparation For Use; Power On And Preset Settings - Agilent Technologies N9342C User Manual

Preparation for Use

This section provides the basic system
configuration which is frequently used before or
after the measurement operation.

Power On and Preset Settings

Selecting a preset type
Press [SYS] > {PwrOn/Off Preset} > {Preset Type} to
choose the preset types. The analyzer has three
types of preset setting for you to choose from:
DFT
settings. The factory default settings can be
found,
User Restores the analyzer to a user- defined
setting. Refer to the descriptions as below.
Last
Saving a User-defined Preset
If you frequently use system settings that are not
the factory defaults, refer to the following steps to
create a user- defined system settings that can be
easily recalled:
1 Set the analyzer parameters using the knob, the
arrow keys, or the numeric keypad.
2 Press [SYS] > {PwrOn/Off Preset} > {Save User} to
save the current parameters as the user preset
setting.
3 Press [SYS] > {PwrOn/Off Preset} > {Preset Type User}
to set the preset mode to user defined system
setting.
4 Press [Preset]. The instrument will be set to the
state you previously saved.
N9342C/43C/44C User's Guide
Restores the analyzer to its factory- defined
"Factory Default Settings"
Restores the analyzer to the last setting.
Getting Started
on page 20.
2
19