Agilent Technologies 8712ET Programmer's Manual page 237

Table 11-19
SUBSYSTEM COMMANDS
SENSe[1|2]:CORRection:CKIT:LOAD
:MODify:DELay? #0~1e-06[S]#
SENSe[1|2]:CORRection:CKIT:LOAD
:MODify:LOSS? #0~1e+12#
SENSe[1|2]:CORRection:CKIT:LOAD
:MODify:ZOFFset? #25~100[OHM]#
SENSe[1|2]:CORRection:CKIT:MODify
[:SElect]
<TYPenf|TYPenm|UD1|TYPe35mm
|TYPeff|TYPe716f|TPe716m|UD2
|TYPeapc7|UD3|UD4|...|UD10>
SENSe[1|2]:CORRection:CKIT:NAME
<KIT1|KIT2|...|KIT10>,<STRING>
SENSe[1|2]:CORRection:CKIT:OPEN
:MODify:CONE? #-10000~1[FARAD]#
SENSe[1|2]:CORRection:CKIT:OPEN
:MODify:CTHRee? #-10000~1[FARAD]#
SENSe[1|2]:CORRection:CKIT:OPEN
:MODify:CTWO? #-10000~1[FARAD]#
SENSe[1|2]:CORRection:CKIT:OPEN
:MODify:CZERo? #-10000~1[FARAD]#
SENSe[1|2]:CORRection:CKIT:OPEN
:MODify:DELay? #0~1e-06[S]#
SENSe (2 of 16)
Programmer's Guide
SCPI Device Command Summary
FORM
NR3 Sets or queries the cal kit load
standard offset delay time.
NR3 Sets or queries the cal kit load
standard offset loss value.
NR1 Sets or queries the cal kit load
standard offset impedance
value.
CHAR Selects or queries the cal kit
connector type. Select
TYPe716f or TYPe716m for
modifiable cal kit.
STRING Sets the description of the
user-defined calibration kit.
NR3 Sets or queries the cal kit open
standard fringe capacitance C1
1
(f , Farad/Hz) value.
NR3 Sets or queries the cal kit open
standard fringe capacitance C3
3
(f , Farad/Hz
NR3 Sets or queries the cal kit open
standard fringe capacitance C2
2
(f , Farad/Hz
NR3 Sets or queries the cal kit open
standard fringe capacitance
model C0 (f
NR3 Modifies or queries the cal kit
open standard offset delay
time.
SCPI Command Summary
DESCRIPTION
3
) value.
2
) value.
0
, Farad) value.
11-39