Agilent Technologies 8712ET Programmer's Manual page 228

Table 11-12
SUBSYSTEM COMMANDS
INITiate[1|2]:CONTinuous
1
<ON|OFF>
INITiate[1|2][:IMMediate]
1. Binary parameters accept the values of 1 (on) and 0 (off) in addition to ON and OFF.
Table 11-13
SUBSYSTEM COMMANDS
INPut:GAIN:AUTo <R|A|B>,<ON|OFF>
INPut:GAIN:SETTing <R|A|B>,
<HIGH|MEDHIGH|MEDIUM|LOW>
SCPI Command Summary
SCPI Device Command Summary
INITiate
INPut
11-30
FORM
NR1 Sets the trigger system to
continuously sweep or to stop
sweeping.
command Initiates a new measurement
only sweep.
FORM
command Sets the R, A, or B IF input
only automatic gain control on or off.
command Sets the R, A, or B IF input gain
only to one of four choices: high,
medium-high, medium, or low.
DESCRIPTION
DESCRIPTION
Programmer's Guide