Agilent Technologies 8712ET Programmer's Manual page 209

Table 11-2
SUBSYSTEM COMMANDS
CALCulate[1|2]
:MARKer[1|2|8]:X <num>
CALCulate[1|2]
:MARKer[1|2|8]:X:ABS <num>
CALCulate[1|2]
:MARKer[1|2|8]:Y?
CALCulate[1|2]
:MARKer[1|2|8]:Y:INDuctance?
CALCulate[1|2]
:MARKer[1|2|8]:Y:MAGNitude?
CALCulate[1|2]
:MARKer[1|2|8]:Y:PHASe?
CALCulate[1|2]
:MARKer[1|2|8]:Y:REACtance?
CALCulate[1|2]
:MARKer[1|2|8]:Y:RESistance?
CALCulate[1|2]
:MATH[:EXPRession] <expr>
1. <expr> and EXPR represent expressions, a parameter type that consists of mathe-
matical expressions that use character parameters and are enclosed in parentheses.
CALCulate (7 of 7)
1
Programmer's Guide
FORM
NR3 Sets the specified marker frequency
(or power if in power sweep).
NR? Sets a marker to an absolute value
(such as frequency or amplitude). The
set value is not relative to a reference
marker if one is enabled.
query Queries the specified marker
only NR3 amplitude.
query Queries the specified marker's
only NR3 inductance when in Smith chart
format.
query Queries the specified marker's
only NR3 magnitude when in polar format.
query Queries the specified marker's phase
only NR3 value when in polar format.
query Queries the specified marker's
only NR3 reactance value when in Smith chart
format.
query Queries the specified marker's
only NR3 resistance value when in Smith chart
format.
EXPR Selects a trace math expression —
choose measurement trace from
(IMPL) for "data only" or
(IMPL/CH<1|2>SMEM) for "data /
memory".
SCPI Command Summary
SCPI Device Command Summary
DESCRIPTION
11-11