Agilent Technologies 8712ET Programmer's Manual page 234

Table 11-17
SUBSYSTEM COMMANDS
PROGram [:SELected]
PROGram [:SELected]
<string>,<data>
PROGram [:SELected]
<char>
PROGram [:SELected]
<string1>,<string2>
PROGram [:SELected]
1. Commands grouped under the SELected mnemonic in the PROGram subsystem
operate on the active program buffer.
2. The parameter type of the data is determined by the format selected — FORMat
REAL uses BLOCK data, FORMat ASCii uses NR3 data separated by commas.
SCPI Command Summary
SCPI Device Command Summary
PROGram (2 of 2)
1
:NAME 'PROG'
1
:NUMBer
2
1
:STATe
1
:STRing
1
:WAIT
11-36
FORM
STRING Selects the IBASIC program in
the program buffer to be active.
BLOCK Loads a new value for a numeric
variable string in the active
2
or NR3
IBASIC program — num is the
new value.
CHAR Selects the state of the active
IBASIC program — choose from
STOP|PAUSe|RUN|CONTinue.
STRING Loads a new value for a string
variable string1 in the active
IBASIC program — string2 is
the new value.
NR1 Waits until the IBASIC program
completes.
DESCRIPTION
Programmer's Guide