Agilent Technologies 8712ET Programmer's Manual page 150

Table 10-7
KEYSTROKES
(Fault Location)
CAL,
Default Cal
Full Band Cal
Measure Standard
Velocity Factor
Cable Loss
Calibrate Cable
Specify Length
Measure Cable
Multi Peak
Multi Peak Corr on OFF
Multi Peak Threshold
Connector Values
Connector Length
Connector C
More Cal
(see Table 10-11 on page
1. Pressing this key begins a guided calibration procedure using three standards.
When the calibration is complete, the command *WAI;:SENS[1|2]:CORR:COLL:
SAVE;*WAI is executed. The order of appearance and the content of the softkey
menus depend on the measurement channel 1 and measurement channel 2 configu-
ration.
Menu Map with SCPI Commands
Menu Map for 8712ET/ES and 8714ET/ES
, Functions, 8712ET/ES and 8714ET/ES
CAL
SENS[1|2]:CORR:CSET DEF; *WAI
SENS[1|2]:CORR:EXT [ON|OFF]
1
SENS[1|2]:CORR:COLL STAN[1|2|3];*WAI
SENS[1|2]:CORR:RVEL:COAX <value>
SENS[1|2]:CORR:LOSS:COAX <value>
(menu selection only)
SENS[1|2]:CORR:LENG:COAX <value>; *WAI
SENS[1|2]:CORR:RVEL; *WAI
(menu selection only)
SENS[1|2]:CORR:PEAK:COAX ON
SENS[1|2]:CORR:THRESHOLD:COAX -10.00
(menu selection only)
SENS[1|2]:CORR:LENG:CONN <value>
SENS1:CORR:CAP:CONN <value>
(menu selection only)
10-26)
10-22
SCPI COMMAND
Programmer's Guide