Agilent Technologies 8712ET Programmer's Manual page 252

Table 11-20
SUBSYSTEM COMMANDS
SOURce[1|2]:POWer[:LEVel]
[:IMMediate][:AMPLitude]<num>
SOURce:POWer:PRESet <num>
SOURce[1|2]:POWer:RANGe <char>
SOURce[1|2]:POWer:STARt <num>
SOURce[1|2]:POWer:STOP <num>
1. Numeric parameters may include an appropriate suffix; if no suffix is included, the
default (HZ for frequency or S for time) is assumed.
SCPI Command Summary
SCPI Device Command Summary
SOURce
1
11-54
FORM
NR3 Sets the RF power output from the
source.
NR3 Sets the power level that the
analyzer will always return to after
an instrument preset.
CHAR Specifies the power sweep range.
Choose from ATTen0
|ATTen10|ATTen20|ATTen30
|ATTen40 |ATTen50|ATTen60.
NR3 Sets the power sweep start power.
NR3 Sets the power sweep stop power.
DESCRIPTION
Programmer's Guide