Performing Your Own Data Processing - Agilent Technologies 8712ET Programmer's Manual

Trace Data Transfers

Performing Your Own Data Processing

Performing Your Own Data Processing
After the analyzer has made a measurement, you can read the
measurement trace and perform your own post-processing on it, and
display the result on the screen. This is done using these steps:
1. Initiate a sweep.
2. Wait for the sweep to finish.
3. Read the measurement data into an array in your program.
4. Perform your post-processing on the measurement data.
5. Write (download) the post-processed data to the analyzer's memory
trace.
You may want to instruct the analyzer to display only the memory trace
and not the data trace, so that only your post-processed data is seen.
6-18 Programmer's Guide