Agilent Technologies 8712ET Programmer's Manual page 245

Table 11-19
SUBSYSTEM COMMANDS
SENSe[1|2]:CORRection:TESTSET
SENSe[1|2]:CORRection:THReshol
d:COAX <num>
SENSe[1|2]:COUPle <char>
SENSe[1|2]:DETector[:FUNCtion]
<char>
SENSe[1|2]:DISTance:CENTer
<num>
SENSe[1|2]:DISTance:STARt
<num>
SENSe[1|2]:DISTance:UNITs
<char>
SENSe[1|2]:DISTance:STOP <num>
SENSe[1|2]:FREQuency:CENTer
2
<num>
1. For use with fault location measurements on analyzers with Option 100 only.
2. Numeric parameters may include an appropriate suffix; if no suffix is included, the
default (HZ for frequency or S for time) is assumed.
SENSe (10 of 16)
Programmer's Guide
FORM
command
Brings up the Test Set Cal menu.
only
NR2 Selects multi-peak threshold value,
1
in dB.
CHAR Turns the alternate sweep mode
on/off — choose ALL (coupled sweep)
or NONE (alternate sweep).
CHAR Specifies which detection mode is
used to make the measurement —
choose BBANd (broadband) or NBANd
(narrowband).
NR3 Sets the center distance for a fault
location measurement, in
feet or meters.
NR3 Sets the start distance for a fault
location measurement, in feet or
meters.
CHAR Specifies distance units. Choose
METers or FEET.
NR3 Sets the stop distance for a fault
location measurement, in feet or
meters.
NR3 Sets the center frequency of the RF
source.
SCPI Command Summary
SCPI Device Command Summary
DESCRIPTION
1
1
1
1
2
11-47