Agilent Technologies 8712ET Programmer's Manual page 244

Table 11-19
SUBSYSTEM COMMANDS
SENSe[1|2]:CORRection:MODel
:CONNector[:IMMediate]
SENSe[1|2]:CORRection:OFFSet
:PHASe
SENSe[1|2]:CORRection:ONEPort
:REFLection[:IMMediate]
SENSe[1|2]:CORRection:ONEPort
:TRANSmission[:IMMediate]
SENSe[1|2]:CORRection:TWOPort
[:IMMediate]
SENSe[1|2]:CORRection:PEAK
:COAX[:STATe]<ON|OFF>
SENSe:CORRection:RVELocity
3
:COAX <num>
SENSe[1|2]:CORRection:RVELocity
[:IMMediate]
1. Binary parameters accept the values of 1 (on) and 0 (off) in addition to ON and OFF.
2. For use with fault location measurements on analyzers with Option 100 only.
3. Numeric parameters may include an appropriate suffix; if no suffix is included, the
default (HZ for frequency or S for time) is assumed.
SCPI Command Summary
SCPI Device Command Summary
SENSe (9 of 16)
1
11-46
FORM
command Measures the cable connector and
only determine the optimum values for
connector length and connector
capacitance.
NR3 Specifies the phase offset.
command Retrieves the user one-port
only reflection error correction factors
from internal memory and applies
them to the current measurement.
command Retrieves the user one-port
only transmission error correction
factors from internal memory and
applies them to the current
measurement.
command Retrieves the user two-port error
only correction factors from internal
memory and applies them to the
current measurement.
NR1 Turns multi-peak correction on or
2
off.
NR3 Specifies the velocity factor to be
used when displaying the distance
for electrical length and port
extensions. 1.0 the speed of light.
command Measures the cable and determine
only the optimum values for cable loss
and velocity factor.
DESCRIPTION
3
2
Programmer's Guide