Agilent Technologies 8712ET Programmer's Manual page 263

Table 11-23
SUBSYSTEM COMMANDS
SYSTem:PRESet
SYSTem:SET <block>
SYSTem:SET:LRN? [<USER>]
SYSTem:SET:LRNLong? [<USER>]
SYSTem:TIME <num1>,<num2>,<num3>
SYSTem:VERSion?
1. Refer to "Automated Measurement Setup and Control" in Chapter 7 of the User's
Guide for more information on using this command.
SYSTem (7 of 8)
1
1
Programmer's Guide
SCPI Device Command Summary
FORM
command Performs a system preset —
only this is the same as the front
panel
command Sends a learn string (obtained
only using *LRN?) to the analyzer
— this command is included in
the learn string.
BLOCK Queries or set the instrument
state.
BLOCK Queries or set the instrument
state, data, and calibration.
Similar to save/recall.
NR1, NR1, Sets the hour (num1), minute
NR1 (num2) and second (num3) of
the real time clock.
query only Queries the SCPI version of
NR2 the analyzer. See *IDN? to
query the firmware revision.
SCPI Command Summary
DESCRIPTION
key.
PRESET
11-65