Agilent Technologies 8712ET Programmer's Manual page 246

Table 11-19
SUBSYSTEM COMMANDS
SENSe[1|2]:FREQuency:MODE <char>
SENSe[1|2]:FREQuency:SPAN <num>
SENSe[1|2]:FREQuency:SPAN
:MAXimum <num>
SENSe[1|2]:FREQuency:STARt <num>
SENSe[1|2]:FREQuency:STOP <num>
SENSe[1|2]:FREQuency:ZSTOp
1
<num>
SENSe[1|2]:FUNCtion?
1. Numeric parameters may include an appropriate suffix; if no suffix is included, the
default (HZ for frequency or S for time) is assumed.
2. For use with fault location measurements on analyzers with Option 100 only.
SCPI Command Summary
SCPI Device Command Summary
SENSe (11 of 16)
1
11-48
FORM
CHAR Sets the fault location
measurement to CENTer
(bandpass) or LOWPass.
1
NR3 Sets the frequency span of the
RF source.
NR3 Sets the maximum frequency
span of the RF source for
bandpass fault location
measurements.
NR3 Sets the start frequency of the
1
RF source.
1 NR3 Sets the stop frequency of the
RF source.
NR3 Sets the Z cutoff frequency for
cable impedance calculations.
query only See SENSe[1|2]:FUNction
STRING
'. . . . .' commands for
string definitions.
Queries the measurement
function — returns a string
that defines the current
measurement function.
DESCRIPTION
2
2
Programmer's Guide
2