Test Results; Blade Inventory - Quantum Scalar i6000 User Manual

Hide thumbs Also See for Scalar i6000:

Table of Contents

Table 39 Test Results

Test Results

Quantum Scalar i6000 User's Guide

This inventory list provides the following information about each Fibre

Channel I/O blade:

• Location of each blade

• Serial number

• Firmware version

Test Results

The results of all subtests appear on the Verification Tests dialog box

after each individual test is completed. See

of test results.

Completed the test without reported errors.

An error has been found and needs to be corrected. A fatal error, or an error that

causes a part of the system to become disabled, will halt the test.

This portion of a test was incomplete due to an interruption or a portion of the

test was run (for example, no scratch tape was used so must only use existing

tapes). An incomplete will occur when the door is opened, an abort command is

issued, or when the Robotics Enable button is pressed.

This portion of the test was skipped. The cause is that either a scratch tape was

not present or the library was not configured for the test.

A warning is additional information about the test that the user should know.

For example, if a calibration failed, but the stored offsets are analyzed, a warning

should be posted that states that the offset check might not be accurate.

The test was interrupted. The log will show the result to provide a record of test

interruption.

Note: A single problem in the library can cause failed results in

multiple tests. After taking action to correct a failed result, run

tests that yielded failed results again.

Chapter 15: Maintaining Your Library

Maintenance Actions

for an explanation