Removing An Air Filte - Quantum Scalar i6000 User Manual

Removing an Air Filter
Quantum Scalar i6000 User's Guide
see dust and debris on the inlet side of the filters, remove the filters and
use water and a mild soap to clean them. The materials in the filters
should last for the life of the product. However, if abnormal
contamination occurs, you should replace them. To order filters, contact
your service representative.
Use these instructions to remove either a top or bottom air filter.
Required tools: #1 Phillips screwdriver
FRU ID: 1001 (air filter)
1 Take the library offline.
For information about taking the library offline, see
Library's State on page 450.
2 On the operator panel, press Robotics Enabled to turn off power to
the picker and return it to the home position.
The power is on to all other components.
3 Open the access door.
Aisle power is disabled.
4 Use the Phillips screwdriver to unscrew the two retaining
thumbscrews. The screws remain attached to the retaining bar.
Chapter 15: Maintaining Your Library
Maintaining Air Filters
Changing the
659