Quantum Scalar i6000 User Manual page 310

Chapter 8: Encryption Key Management
Setting up EKM on the Scalar i6000
296
server to match or Q-EKM will not work properly. See the
Quantum Encryption Key Manager User's Guide
on setting the port number on the Q-EKM key server.
d Secondary EKM Server - Type the IP address or DNS name of
the optional secondary Q-EKM server.
Note: If you do not plan to use a secondary server, you may
type a zero IP address, 0.0.0.0, into the Secondary EKM
Server text box, or you may leave this text box blank.
e Secondary port number - If SSL is enabled, the default port
number is 443. If SSL is not enabled, the default port number is
3801.
Note: If you are using a secondary key server, then the port
numbers for both the primary and secondary key
servers must be set to the same value. If they are not,
synchronization and failover will not occur.
f Key Class - This field is not applicable for Q-EKM.
g EKM Path Diagnostics - Not supported for Q-EKM. The Test
button is disabled.
SKM
a Enable SSL - Check box is checked automatically and field is
disabled.
b Primary EKM Server - Type the IP address or DNS name of the
primary SKM server.
c Primary port number - Field is disabled, and port number
defaults to 6000 automatically.
d Secondary EKM Server - Type the IP address or DNS name of
the secondary SKM server.
e Secondary port number - Field is disabled, and port number
defaults to 6000 automatically.
f Key Class - This field is not applicable for SKM.
g EKM Path Diagnostics - To test the configuration, click Test.
The Path Diagnostic Results dialog box appears. For more
information on EKM Path Diagnostics, see
for information
Using EKM Path
Quantum Scalar i6000 User's Guide