Outgoing E-Mail Server Cli Commands; Sending A Test E-Mail - Quantum DXi V-Series Manual

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-09 Rev B
February 2014
Outgoing E mail Server
-
CLI Commands

Sending a Test E-mail

78
This CLI command allows the admin user to delete the specified e-mail recipient.
Deleting All E Mail Recipients
-
syscli --deleteall emailrecipient [--sure]
This CLI command allows the admin user to delete all e-mail recipients. If the
--sure option is specified, the user will not be prompted for confirmation.
The following e-mail server CLI commands are supported:
• Displaying the Outgoing E-mail Server
• Setting the Outgoing E-mail Server
• Deleting the Outgoing E-mail Server
Displaying the Outgoing E-mail Server
syscli --get emailserver
This CLI command allows the user to display the outgoing e-mail server. An
example output of the outgoing e-mail server is shown below.
Outgoing E‐mail Server
Host name or IP address = 10.40.164.50
From Email address = DX75@quantum.com
Setting the Outgoing E-mail Server
syscli --set emailserver --hostname <server_name_or_IP> --emailaddr
<from_email_address>
This CLI command allows the admin user to add an outgoing e-mail server that
will be used to send the e-mail to configured recipients.
Deleting the Outgoing E-mail Server
syscli --del emailserver
This CLI command allows the admin user to delete an outgoing e-mail server.
syscli --send testemail --name <recipient_name>
This CLI command allows the admin user to send a test e-mail to verify the
e-mail configuration.
Other System Configuration CLI Commands